, (3) With a flick of the lever, my bridge appears just when I need it, no exposed redstone, or troublesome wiring to boot!
(2) Now, when I press the lever one way, the bridge disappears, keeping unwanted elements at bay.
#MINECRAFT MODDING 1.9 FLUID BLOCKS ACTIVATOR#
You can do so without worrying about redstone being visible by running the redstone wire that is connected to your torches up and underneath the block that is your lever, or that the other redstone activator is on. (1) Here I have wired up my torches to a redstone lever. Step 4 Wire Up Your Bridge to a Lever or Other Redstone Activator Instead, double up on repeaters as seen above. (4) On each end of the redstone torches, DO NOT alternate redstone wire and redstone repeaters. Be sure to run connecting wire behind the repeaters so that a current will travel through the whole system. To do so, alternate redstone repeaters with redstone wire so that it runs into the torches as seen above. Wire up the torches together using redsone. , (3) Dig around the second (lower) level of redstone torches until you have a two block wide space on either side. This will deactivate the top redstone torches, thus deactivating your bridge. , (2) Now do the same thing you just did by removing one block from underneath the redstone torches you just placed, and place a second double line of redstone torches beneath these. This will momentarily activate the pistons. (1) Remove one block from underneath your pistons the full length of the bridge.
0 kommentar(er)
